Skip to content
ENES
Marketplace

How deep are water wells in Whitehouse, Texas?

Home water wells in and around Whitehouse, Texas vary a lot in depth: the middle half are 131 to 540 feet deep (median 290 ft, 51 wells reported since 2001), so look at the wells closest to the tract. Estimated cost of a complete well at the median depth: $10,000 to $24,000.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointSmith County
What is under Whitehouse, TexasUnderground column at the center of Whitehouse: median well 290 ft, middle half 131 to 540 ft, water at 85 ft.No state layer model here yet0200400600800ftGround levelMedian well: 290 ftWater standing in the well from 85 ftWater level85 ftMiddle half131–540 ftMedian well290 ft

Under Whitehouse, Smith County

The well and the water are the median of 51 real wells. This atlas does not have a state layer model for this area yet.

Home wells in and around Whitehouse

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Whitehouse and about 2 miles around it

Key figures

Typical depth (middle half)
131 to 540 feet
Median depth
290 feet
Deepest 10% are past
650 feet
Water level (median)
85 feet
50 wells
Yield (median)
30 gpm
50 wells, gallons per minute
Wells used
51
Since 2001
Inside the city limits
6
the rest within 2 miles
All years on file
51
median 290 ft, since 2002
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 85 feet below the surface (50 wells), well above the bottom: the typical well holds about 205 feet of water.

What is under Whitehouse, TexasUnderground column at the center of Whitehouse: median well 290 ft, middle half 131 to 540 ft, water at 85 ft.No state layer model here yet0200400600800ftGround levelMedian well: 290 ftWater standing in the well from 85 ftWater level85 ftMiddle half131–540 ftMedian well290 ft
The well and the water are the median of 51 real wells. This atlas does not have a state layer model for this area yet.

Which formation do wells in Whitehouse draw from?

We cannot say yet for Whitehouse. This atlas assigns layers with the TWDB layered models processed so far (the Northern Trinity and Woodbine model, the Hill Country Trinity model, the northern Gulf Coast Aquifer model and the High Plains Aquifer System model), and none covers this area with enough wells. The depth, water level and yield on this page do come from the real wells here.

See the aquifers mapped under Smith County

Depth over time

There are not enough wells in both 2003 to 2007 and 2021 to 2025 (at least 30 in each) to say with confidence whether wells in and around Whitehouse are getting deeper. For reference, the median was 240 feet in 2006 to 2010 (16 wells) and 540 feet in 2021 to 2025 (16 wells).

PeriodMedian depth (ft)Wells
2001–2005under 10 wells6
2006–201024016
2011–2015under 10 wells7
2016–2020under 10 wells5
2021–202554016
2026under 10 wells1

What a well costs in Whitehouse

At the median depth for Whitehouse (290 feet), a complete home well would cost roughly $10,000 to $24,000: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (131 to 540 feet) the range runs from $6,000 to $39,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Whitehouse, Texas?

Home water wells in and around Whitehouse, Texas vary a lot in depth: the middle half are 131 to 540 feet deep (median 290 ft, 51 wells reported since 2001), so look at the wells closest to the tract. One in ten goes past 650 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

How much does a water well cost in Whitehouse?

At the median depth (290 feet), a complete well would cost roughly $10,000 to $24,000, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Whitehouse?

When the wells were finished, the water stood a median 85 feet below the surface (50 wells), well above the bottom: the typical well holds about 205 feet of water. The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Whitehouse?

In the state's boundary file (current as of November 2019) no groundwater conservation district covers Whitehouse. Districts created or enlarged since then are missing from that file, so confirm with the county or TWDB before drilling. Anywhere in Texas the well must be drilled by a licensed driller, who files the report with the state.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/whitehouse-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources