Skip to content
ENES
Marketplace

How deep are water wells in Spring Branch, Texas?

Home water wells in and around Spring Branch, Texas are typically 420 to 500 feet deep (median 464 ft, 199 wells drilled in the last 10 years). Most draw from the Lower Trinity (70%), and 30% draw from the Middle Trinity, according to the state's Hill Country Trinity model (TWDB). Estimated cost of a complete well at the median depth: $14,000 to $34,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointComal County
What is under Spring Branch, TexasUnderground column at the center of Spring Branch: median well 464 ft, middle half 420 to 500 ft, water at 238 ft, and the layers of the state's model with their thickness.Middle Trinity: 0 to 206 ftMiddle TrinityLower Trinity: 206 to 584 ftLower Trinity0200400600ftGround level · 1,118 ft above sea levelMedian well: 464 ftWater standing in the well from 238 ftWater level238 ftMiddle half420–500 ftMedian well464 ft

Under Spring Branch, Comal County

Layers at the center of Spring Branch from TWDB's Hill Country Trinity model (1 mile cells), at true depth scale. The well and the water are the median of 199 real wells.

Home wells in and around Spring Branch

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Spring Branch and about 2 miles around it

Key figures

Typical depth (middle half)
420 to 500 feet
Median depth
464 feet
Deepest 10% are past
540 feet
Water level (median)
238 feet
66 wells
Yield (median)
10 gpm
137 wells, gallons per minute
Wells used
199
In the last 10 years
Inside the city limits
10
the rest within 2 miles
All years on file
672
median 460 ft, since 2001
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 238 feet below the surface (66 wells).

What is under Spring Branch, TexasUnderground column at the center of Spring Branch: median well 464 ft, middle half 420 to 500 ft, water at 238 ft, and the layers of the state's model with their thickness.Middle Trinity: 0 to 206 ftMiddle TrinityLower Trinity: 206 to 584 ftLower Trinity0200400600ftGround level · 1,118 ft above sea levelMedian well: 464 ftWater standing in the well from 238 ftWater level238 ftMiddle half420–500 ftMedian well464 ft
Layers at the center of Spring Branch from TWDB's Hill Country Trinity model (1 mile cells), at true depth scale. The well and the water are the median of 199 real wells.

Which formation do wells in Spring Branch draw from?

Most draw from the Lower Trinity (70%), and 30% draw from the Middle Trinity, according to the state's Hill Country Trinity model (TWDB). Read that as the most likely layer, not a certain one: where our method names the Lower Trinity, the state's own aquifer code agrees in about 53% of wells.

Going by the bottom of the hole instead of where the water enters, 84% reach the Lower Trinity.

Layer (state's model)ShareWellsTypical depth (ft)
Lower Trinity70%139442–503
Middle Trinity30%60263–448

For 99% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

The layers under the center of Spring Branch

From the state's model, at 1,118 feet above sea level. These are the model's depths at that one point, not those of any particular lot.

Depths in feet below ground.
Layer (state's model)Top (ft)Bottom (ft)Thickness (ft)
Middle Trinitylimestone and sand0206206
Lower Trinitysand and limestone206584377

Depth over time

Home well depth in and around Spring Branch has not changed meaningfully in 20 years: the median was 460 feet in 2003 to 2007 and 480 feet in 2021 to 2025 (a difference under 10% or within the margin of error).

PeriodMedian depth (ft)Wells
2001–2005440201
2006–2010460156
2011–2015450101
2016–2020470113
2021–202548089
202644412

What a well costs in Spring Branch

At the median depth for Spring Branch (464 feet), a complete home well would cost roughly $14,000 to $34,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (420 to 500 feet) the range runs from $13,000 to $36,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Spring Branch, Texas?

Home water wells in and around Spring Branch, Texas are typically 420 to 500 feet deep (median 464 ft, 199 wells drilled in the last 10 years). One in ten goes past 540 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

What aquifer or formation do wells in Spring Branch draw from?

Most draw from the Lower Trinity (70%), and 30% draw from the Middle Trinity, according to the state's Hill Country Trinity model (TWDB). Read that as the most likely layer, not a certain one: where our method names the Lower Trinity, the state's own aquifer code agrees in about 53% of wells. This is an estimate from the state's regional model, not a survey of the lot.

How much does a water well cost in Spring Branch?

At the median depth (464 feet), a complete well would cost roughly $14,000 to $34,500, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Spring Branch?

When the wells were finished, the water stood a median 238 feet below the surface (66 wells). The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Spring Branch?

Spring Branch is inside the Comal Trinity Groundwater Conservation District. Groundwater conservation districts in Texas can require registering or permitting a new well, keeping set distances from property lines and other wells, and paying fees. Rules differ from district to district: ask the district before drilling.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 99% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How well it works: In 2,665 wells in the Texas Hill Country where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 76% of them, and that layer or the one next to it in at least 98%.

  • The layers come from the Texas Water Development Board's Hill Country Trinity model, with 1 mile cells. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
  • "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/spring-branch-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources