Water wells in the Comal Trinity Groundwater Conservation District

Common questions

What a well costs here

At the median depth for the district (484 feet), a complete home well would cost roughly $14,500 to $35,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (400 to 600 feet) the range runs from $12,500 to $42,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the district boundary. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 98% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How well it works: In 2,665 wells in the Texas Hill Country where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 76% of them, and that layer or the one next to it in at least 98%.

• The layers come from the Texas Water Development Board's Hill Country Trinity model, with 1 mile cells. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
• "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
• We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/districts/comal-trinity-groundwater-conservation-district. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources

• Submitted Driller's Reports database, Texas Water Development Board (TWDB) (file of November 10, 2026)
• Groundwater Availability Model for the Hill Country portion of the Trinity Aquifer System, Texas. Jones, I.C., Anaya, R., and Wade, S.C., Texas Water Development Board, 2009, GAM v2.01 (MODFLOW-96). TWDB groundwater availability model.
• Groundwater conservation district boundaries, TWDB (current as of November 2019)
• Ground elevation: Terrain Tiles (Mapzen), Registry of Open Data on AWS
• TWDB well report viewer (each well's official report)