Skip to content
ENES
Marketplace

How deep are water wells in Liberty City, Texas?

Home water wells in and around Liberty City, Texas are typically 398 to 500 feet deep (median 460 ft, 34 wells drilled in the last 10 years). Estimated cost of a complete well at the median depth: $14,000 to $34,000.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointGregg County
What is under Liberty City, TexasUnderground column at the center of Liberty City: median well 460 ft, middle half 398 to 500 ft, water at 165 ft.No state layer model here yet0200400600ftGround levelMedian well: 460 ftWater standing in the well from 165 ftWater level165 ftMiddle half398–500 ftMedian well460 ft

Under Liberty City, Gregg County

The well and the water are the median of 34 real wells. This atlas does not have a state layer model for this area yet.

Home wells in and around Liberty City

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Liberty City and about 2 miles around it

Key figures

Typical depth (middle half)
398 to 500 feet
Median depth
460 feet
Deepest 10% are past
520 feet
Water level (median)
165 feet
18 wells
Yield (median)
30 gpm
28 wells, gallons per minute
Wells used
34
In the last 10 years
Inside the city limits
16
the rest within 2 miles
All years on file
96
median 454 ft, since 2002
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 165 feet below the surface (18 wells), well above the bottom: the typical well holds about 295 feet of water.

What is under Liberty City, TexasUnderground column at the center of Liberty City: median well 460 ft, middle half 398 to 500 ft, water at 165 ft.No state layer model here yet0200400600ftGround levelMedian well: 460 ftWater standing in the well from 165 ftWater level165 ftMiddle half398–500 ftMedian well460 ft
The well and the water are the median of 34 real wells. This atlas does not have a state layer model for this area yet.

Which formation do wells in Liberty City draw from?

We cannot say yet for Liberty City. This atlas assigns layers with the TWDB layered models processed so far (the Northern Trinity and Woodbine model, the Hill Country Trinity model, the northern Gulf Coast Aquifer model and the High Plains Aquifer System model), and none covers this area with enough wells. The depth, water level and yield on this page do come from the real wells here.

See the aquifers mapped under Gregg County

Depth over time

There are not enough wells in both 2003 to 2007 and 2021 to 2025 (at least 30 in each) to say with confidence whether wells in and around Liberty City are getting deeper. For reference, the median was 436 feet in 2001 to 2005 (12 wells) and 460 feet in 2021 to 2025 (17 wells).

PeriodMedian depth (ft)Wells
2001–200543612
2006–201044018
2011–201545230
2016–202046017
2021–202546017
2026under 10 wells2

What a well costs in Liberty City

At the median depth for Liberty City (460 feet), a complete home well would cost roughly $14,000 to $34,000: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (398 to 500 feet) the range runs from $12,500 to $36,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Liberty City, Texas?

Home water wells in and around Liberty City, Texas are typically 398 to 500 feet deep (median 460 ft, 34 wells drilled in the last 10 years). One in ten goes past 520 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

How much does a water well cost in Liberty City?

At the median depth (460 feet), a complete well would cost roughly $14,000 to $34,000, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Liberty City?

When the wells were finished, the water stood a median 165 feet below the surface (18 wells), well above the bottom: the typical well holds about 295 feet of water. The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Liberty City?

In the state's boundary file (current as of November 2019) no groundwater conservation district covers Liberty City. Districts created or enlarged since then are missing from that file, so confirm with the county or TWDB before drilling. Anywhere in Texas the well must be drilled by a licensed driller, who files the report with the state.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/liberty-city-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources