Skip to content

Lower Trinity: how deep the wells are

Home water wells that draw from the Lower Trinity in the Texas Hill Country are typically 420 to 658 feet deep (median 510 ft, 1,875 wells drilled in the last 10 years). In the state's model it is sand and limestone. It carries the most weight in Travis County (46% of its wells), Hays County (41% of its wells) and Comal County (35% of its wells). Estimated cost of a complete well at the median depth: $15,500 to $37,000.

Checked against the state's own aquifer codes: where our method names this layer, the state agrees in 53% of 426 wells. Read it as the likely layer, not a certain one.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

Depth of wells in the Lower Trinity, by countyThe dot is the median and the bar the middle half for each county. The table below has the figures.02505007501,000 ftTravisTravis: 265–708 ftTravis: 430 ft430HaysHays: 464–725 ftHays: 530 ft530ComalComal: 420–520 ftComal: 480 ft480KendallKendall: 422–720 ftKendall: 560 ft560BanderaBandera: 460–640 ftBandera: 520 ft520KerrKerr: 500–670 ftKerr: 600 ft600BlancoBlanco: 410–660 ftBlanco: 472 ft472MedinaMedina: 830–905 ftMedina: 857 ft857BexarBexar: 500–871 ftBexar: 600 ft600

Under Austin, Travis County

Dot: median. Bar: middle half (25th to 75th percentile). Counties with the most wells in this layer.

What this layer is

The Lower Trinity groups the Sycamore Sand, the Sligo Formation and the Hosston Formation, under the Hammett Shale. It is the deepest of the four layers in the state's Hill Country model, so wells that draw from it are the deepest and cost the most to drill.

Units the model puts in this layer: Sycamore Sand, Sligo Formation, Hosston Formation.

Source of the layers: TWDB's Hill Country Trinity model, with 1 mile cells.

Key figures

Typical depth (middle half)
420 to 658 feet
Median depth
510 feet
Deepest 10% are past
840 feet
Water level (median)
302 feet
1,322 wells
Yield (median)
25 gpm
1,568 wells, gallons per minute
Wells used
1,875
In the last 10 years
All years on file
7,237
median 490 ft, since 1994
Confidence
Standard (30 or more wells)

Counties where homes draw from this layer

Only counties with at least 10 wells in the layer. The share is of the county's wells that the model covers.

Depth of wells in the Lower Trinity, by countyThe dot is the median and the bar the middle half for each county. The table below has the figures.02505007501,000 ftTravisTravis: 265–708 ftTravis: 430 ft430HaysHays: 464–725 ftHays: 530 ft530ComalComal: 420–520 ftComal: 480 ft480KendallKendall: 422–720 ftKendall: 560 ft560BanderaBandera: 460–640 ftBandera: 520 ft520KerrKerr: 500–670 ftKerr: 600 ft600BlancoBlanco: 410–660 ftBlanco: 472 ft472MedinaMedina: 830–905 ftMedina: 857 ft857BexarBexar: 500–871 ftBexar: 600 ft600
Dot: median. Bar: middle half (25th to 75th percentile). Counties with the most wells in this layer.
CountyMedian depth (ft)WellsShare of the county's wells
Travis County43041946%
Hays County53035741%
Comal County48033735%
Kendall County56026422%
Bandera County52022323%
Kerr County60016919%
Blanco County472456%
Medina County8573121%
Bexar County680246%

Places where it is the main layer

Where it sits among the model's layers

From top to bottom, with the median depth of the home wells that draw from each:

Layer (state's model)RockMedian depth (ft)Wells
Edwards Grouplimestone205233
Upper Trinitylimestone and marl245467
Middle Trinitylimestone and sand4805,005
Lower Trinitysand and limestone5101,875

Depth over time

Home well depth in this layer has not changed meaningfully in 20 years: the median was 480 feet in 2003 to 2007 and 520 feet in 2021 to 2025 (a difference under 10% or within the margin of error).

PeriodMedian depth (ft)Wells
2001–20054621,617
2006–20105002,050
2011–20154801,523
2016–2020500958
2021–2025520981
202656098

Common questions

How deep is a well in the Lower Trinity?

Home water wells that draw from the Lower Trinity in the Texas Hill Country are typically 420 to 658 feet deep (median 510 ft, 1,875 wells drilled in the last 10 years).

What is the Lower Trinity?

The Lower Trinity groups the Sycamore Sand, the Sligo Formation and the Hosston Formation, under the Hammett Shale. It is the deepest of the four layers in the state's Hill Country model, so wells that draw from it are the deepest and cost the most to drill.

How deep does the water stand in these wells?

When the wells were finished, the water stood a median 302 feet below the surface (1,322 wells).

What a well in this layer costs

At the median depth for this layer (510 feet), a complete home well would cost roughly $15,500 to $37,000: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (420 to 658 feet) the range runs from $13,000 to $46,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

How these numbers are made

We count new and replacement domestic (home) wells with a valid depth on their report. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 96% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How well it works: In 2,665 wells in the Texas Hill Country where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 76% of them, and that layer or the one next to it in at least 98%.

  • The layers come from the Texas Water Development Board's Hill Country Trinity model, with 1 mile cells. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
  • "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/formations/lower-trinity. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources