Skip to content

Evangeline Aquifer: how deep the wells are

Home water wells that draw from the Evangeline Aquifer in Houston and Southeast Texas are typically 174 to 267 feet deep (median 215 ft, 5,066 wells drilled in the last 10 years). In the state's model it is sand and clay. It carries the most weight in Colorado County (65% of its wells), Austin County (59% of its wells) and Waller County (43% of its wells). Estimated cost of a complete well at the median depth: $8,000 to $19,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

Depth of wells in the Evangeline Aquifer, by countyThe dot is the median and the bar the middle half for each county. The table below has the figures.0100200300400 ftMontgomeryMontgomery: 205–354 ftMontgomery: 250 ft250ColoradoColorado: 150–225 ftColorado: 185 ft185AustinAustin: 185–270 ftAustin: 220 ft220LavacaLavaca: 143–210 ftLavaca: 179 ft179WallerWaller: 210–320 ftWaller: 255 ft255WashingtonWashington: 187–254 ftWashington: 225 ft225GrimesGrimes: 170–304 ftGrimes: 245 ft245TylerTyler: 108–220 ftTyler: 160 ft160San JacintoSan Jacinto: 200–350 ftSan Jacinto: 290 ft290PolkPolk: 160–240 ftPolk: 200 ft200JasperJasper: 131–200 ftJasper: 170 ft170NewtonNewton: 120–185 ftNewton: 160 ft160

Under Conroe, Montgomery County

Dot: median. Bar: middle half (25th to 75th percentile). Counties with the most wells in this layer.

What this layer is

The Evangeline lies under the Chicot and comes to the surface in a belt farther inland (Goliad Sand and the upper Fleming, or Lagarto, Formation), thicker sand and clay that dips toward the coast. Home wells draw from it in Montgomery, Waller, Austin and Colorado counties. The state's well records also put many deeper wells around Houston in it, even where the state's model still shows the Chicot at that depth.

Units the model puts in this layer: Goliad Sand and the upper part of the Fleming (Lagarto) Formation.

Checked against the state's own aquifer codes: where our method names this group, the state agrees in 80% of 2,293 wells (86% for the 648 with a screened interval on their report).

Source of the layers: TWDB's northern Gulf Coast Aquifer model, with cells of about 0.62 mile (1 km).

Key figures

Typical depth (middle half)
174 to 267 feet
Median depth
215 feet
Deepest 10% are past
355 feet
Water level (median)
82 feet
4,895 wells
Yield (median)
40 gpm
4,779 wells, gallons per minute
Wells used
5,066
In the last 10 years
All years on file
12,559
median 218 ft, since 1997
Confidence
Standard (30 or more wells)

Counties where homes draw from this layer

Only counties with at least 10 wells in the layer. The share is of the county's wells that the model covers.

Depth of wells in the Evangeline Aquifer, by countyThe dot is the median and the bar the middle half for each county. The table below has the figures.0100200300400 ftMontgomeryMontgomery: 205–354 ftMontgomery: 250 ft250ColoradoColorado: 150–225 ftColorado: 185 ft185AustinAustin: 185–270 ftAustin: 220 ft220LavacaLavaca: 143–210 ftLavaca: 179 ft179WallerWaller: 210–320 ftWaller: 255 ft255WashingtonWashington: 187–254 ftWashington: 225 ft225GrimesGrimes: 170–304 ftGrimes: 245 ft245TylerTyler: 108–220 ftTyler: 160 ft160San JacintoSan Jacinto: 200–350 ftSan Jacinto: 290 ft290PolkPolk: 160–240 ftPolk: 200 ft200JasperJasper: 131–200 ftJasper: 170 ft170NewtonNewton: 120–185 ftNewton: 160 ft160
Dot: median. Bar: middle half (25th to 75th percentile). Counties with the most wells in this layer.
CountyMedian depth (ft)WellsShare of the county's wells
Montgomery County2501,06829%
Colorado County18584465%
Austin County22075059%
Lavaca County17950340%
Waller County25549343%
Washington County22546528%
Grimes County24527031%
Tyler County16020738%
San Jacinto County29012718%
Polk County20011715%
Jasper County1708611%
Newton County1608321%
Walker County265458%

Places where it is the main layer

Where it sits among the model's layers

From top to bottom, with the median depth of the home wells that draw from each:

Layer (state's model)RockMedian depth (ft)Wells
Chicot Aquifersand, silt and clay24018,759
Evangeline Aquifersand and clay2155,066
Jasper and Catahoula, with the Burkevillesand, sandstone, clay and volcanic tuff2305,628

Depth over time

Home well depth in this layer has not changed meaningfully in 20 years: the median was 210 feet in 2003 to 2007 and 215 feet in 2021 to 2025 (a difference under 10% or within the margin of error).

PeriodMedian depth (ft)Wells
2001–20052172,061
2006–20102102,659
2011–20152252,333
2016–20202152,240
2021–20252152,837
2026223377

Common questions

How deep is a well in the Evangeline Aquifer?

Home water wells that draw from the Evangeline Aquifer in Houston and Southeast Texas are typically 174 to 267 feet deep (median 215 ft, 5,066 wells drilled in the last 10 years).

What is the Evangeline Aquifer?

The Evangeline lies under the Chicot and comes to the surface in a belt farther inland (Goliad Sand and the upper Fleming, or Lagarto, Formation), thicker sand and clay that dips toward the coast. Home wells draw from it in Montgomery, Waller, Austin and Colorado counties. The state's well records also put many deeper wells around Houston in it, even where the state's model still shows the Chicot at that depth.

How deep does the water stand in these wells?

When the wells were finished, the water stood a median 82 feet below the surface (4,895 wells), well above the bottom: the typical well holds about 133 feet of water.

What a well in this layer costs

At the median depth for this layer (215 feet), a complete home well would cost roughly $8,000 to $19,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (174 to 267 feet) the range runs from $7,000 to $22,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

How these numbers are made

We count new and replacement domestic (home) wells with a valid depth on their report. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 95% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How well it works: In 14,333 wells in the area of the state's northern Gulf Coast Aquifer model (Houston and Southeast Texas) where the State of Texas recorded the aquifer, the formation our method says the well draws from (as grouped on these pages) is the one the state recorded in about 83% of them, and that formation or the one next to it in at least 99%; of the 3,578 of those wells that the state records in the Evangeline, it names the Evangeline for about 51% and the Chicot for most of the rest.

  • The layers come from the Texas Water Development Board's northern Gulf Coast Aquifer model, with cells of about 0.62 mile (1 km). It is a regional model, not a survey of any lot.
  • The state's model has cells of about 3,277 ft (1 km, 0.62 mile); we read it on a grid of about 0.6 by 0.7 miles. It is not a survey of any lot, so we give ranges.
  • Figures go by three groups: Chicot, Evangeline, and Jasper and Catahoula with the Burkeville. The state's records cannot tell the Burkeville, the Jasper and the Catahoula apart at a well (alone, the Burkeville matched 33% and the Catahoula 50%), so they are never named one by one as the formation of a well or a place.
  • The line between the Chicot and the Evangeline is drawn differently by different studies. The state's records put about half of their Evangeline wells in what the model draws as the Chicot, mostly deeper wells in Harris, Montgomery, Waller, Liberty and Austin counties. Where both appear, the split is approximate.
  • "Near or below the base" means the well ends near or below the base of the Gulf Coast Aquifer (under the Catahoula: Jackson Group, Yegua and older). It is 1.3% of home wells; half of them end within about 85 ft of the base. That is not an error: the model simply ends there.
  • The model's top layer is a uniform 49 ft slab for the water table zone, not a rock unit; we merge it into the unit beneath. The model also covers Colorado, Lavaca, Fayette, Wharton and Matagorda counties (outside Groundwater Management Area 14), with the same framework. Texas part only.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/formations/evangeline. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources