Water wells in the Jasper and Catahoula aquifers, with the Burkeville, Washington County, Texas

What this layer is

This is the older, deeper half of the Gulf Coast Aquifer: the clay rich Burkeville, the sands of the lower Fleming (Lagarto) and the Oakville Sandstone that make up the Jasper, and the Catahoula sandstone and tuff at the base. They reach the surface in a belt from Fayette and Washington counties to Polk, Tyler and Jasper counties, where home wells draw from them. The state's records cannot reliably tell the three apart at a well, so we report them together.

Checked against the state's own aquifer codes: where our method names this group, the state agrees in 87% of 2,575 wells.

More about the Jasper and Catahoula aquifers, with the Burkeville

Depth over time

Home well depth in this layer in Washington County has not changed meaningfully in 20 years: the median was 252 feet in 2003 to 2007 and 245 feet in 2021 to 2025 (a difference under 10% or within the margin of error).

Common questions

What a well costs here

At the median depth for this layer in Washington County (245 feet), a complete home well would cost roughly $8,500 to $21,000: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (188 to 312 feet) the range runs from $7,000 to $25,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

How these numbers are made

We count new and replacement domestic (home) wells with a valid depth on their report. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 99% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How well it works: In 14,333 wells in the area of the state's northern Gulf Coast Aquifer model (Houston and Southeast Texas) where the State of Texas recorded the aquifer, the formation our method says the well draws from (as grouped on these pages) is the one the state recorded in about 83% of them, and that formation or the one next to it in at least 99%; of the 3,578 of those wells that the state records in the Evangeline, it names the Evangeline for about 51% and the Chicot for most of the rest.

• The layers come from the Texas Water Development Board's northern Gulf Coast Aquifer model, with cells of about 0.62 mile (1 km). It is a regional model, not a survey of any lot.
• The state's model has cells of about 3,277 ft (1 km, 0.62 mile); we read it on a grid of about 0.6 by 0.7 miles. It is not a survey of any lot, so we give ranges.
• Figures go by three groups: Chicot, Evangeline, and Jasper and Catahoula with the Burkeville. The state's records cannot tell the Burkeville, the Jasper and the Catahoula apart at a well (alone, the Burkeville matched 33% and the Catahoula 50%), so they are never named one by one as the formation of a well or a place.
• The line between the Chicot and the Evangeline is drawn differently by different studies. The state's records put about half of their Evangeline wells in what the model draws as the Chicot, mostly deeper wells in Harris, Montgomery, Waller, Liberty and Austin counties. Where both appear, the split is approximate.
• "Near or below the base" means the well ends near or below the base of the Gulf Coast Aquifer (under the Catahoula: Jackson Group, Yegua and older). It is 1.3% of home wells; half of them end within about 85 ft of the base. That is not an error: the model simply ends there.
• The model's top layer is a uniform 49 ft slab for the water table zone, not a rock unit; we merge it into the unit beneath. The model also covers Colorado, Lavaca, Fayette, Wharton and Matagorda counties (outside Groundwater Management Area 14), with the same framework. Texas part only.
• We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/washington-county/jasper-catahoula. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources

• Submitted Driller's Reports database, Texas Water Development Board (TWDB) (file of November 10, 2026)
• Northern Portion of the Gulf Coast Aquifer System Groundwater Availability Model for Groundwater Management Area 14 Joint Planning (GMA 14 Model). Keester, M.R., Webster, P., Beach, J., Drabek, C., and Chen, Y.H. (KT Groundwater and Advanced Groundwater Solutions), for Groundwater Management Area 14, in cooperation with Lone Star Groundwater Conservation District; layer elevations from GULF-2023 (Ellis and others, 2023, U.S. Geological Survey), 2025, GAM v4.1. TWDB groundwater availability model.
• Ground elevation: Terrain Tiles (Mapzen), Registry of Open Data on AWS
• TWDB well report viewer (each well's official report)