Skip to content
ENES
Marketplace

How deep are water wells in Stockdale, Texas?

Home water wells in and around Stockdale, Texas are consistently 380 to 409 feet deep (median 400 ft, 30 wells drilled in the last 10 years). Estimated cost of a complete well at the median depth: $12,500 to $30,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointWilson County
What is under Stockdale, TexasUnderground column at the center of Stockdale: median well 400 ft, middle half 380 to 409 ft, water at 81 ft.No state layer model here yet0100200300400500ftGround levelMedian well: 400 ftWater standing in the well from 81 ftWater level81 ftMiddle half380–409 ftMedian well400 ft

Under Stockdale, Wilson County

The well and the water are the median of 30 real wells. This atlas does not have a state layer model for this area yet.

Home wells in and around Stockdale

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Stockdale and about 2 miles around it

Key figures

Typical depth (middle half)
380 to 409 feet
Median depth
400 feet
Deepest 10% are past
466 feet
Water level (median)
81 feet
29 wells
Yield (median)
65 gpm
30 wells, gallons per minute
Wells used
30
In the last 10 years
Inside the city limits
0
the rest within 2 miles
All years on file
59
median 395 ft, since 2003
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 81 feet below the surface (29 wells), well above the bottom: the typical well holds about 319 feet of water.

What is under Stockdale, TexasUnderground column at the center of Stockdale: median well 400 ft, middle half 380 to 409 ft, water at 81 ft.No state layer model here yet0100200300400500ftGround levelMedian well: 400 ftWater standing in the well from 81 ftWater level81 ftMiddle half380–409 ftMedian well400 ft
The well and the water are the median of 30 real wells. This atlas does not have a state layer model for this area yet.

Which formation do wells in Stockdale draw from?

We cannot say yet for Stockdale. This atlas assigns layers with the TWDB layered models processed so far (the Northern Trinity and Woodbine model, the Hill Country Trinity model, the northern Gulf Coast Aquifer model and the High Plains Aquifer System model), and none covers this area with enough wells. The depth, water level and yield on this page do come from the real wells here.

See the aquifers mapped under Wilson County

Depth over time

There are not enough wells in both 2003 to 2007 and 2021 to 2025 (at least 30 in each) to say with confidence whether wells in and around Stockdale are getting deeper. For reference, the median was 340 feet in 2001 to 2005 (11 wells) and 400 feet in 2021 to 2025 (19 wells).

PeriodMedian depth (ft)Wells
2001–200534011
2006–2010under 10 wells5
2011–2015under 10 wells9
2016–202040014
2021–202540019
2026under 10 wells1

What a well costs in Stockdale

At the median depth for Stockdale (400 feet), a complete home well would cost roughly $12,500 to $30,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (380 to 409 feet) the range runs from $12,000 to $31,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Stockdale, Texas?

Home water wells in and around Stockdale, Texas are consistently 380 to 409 feet deep (median 400 ft, 30 wells drilled in the last 10 years). One in ten goes past 466 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

How much does a water well cost in Stockdale?

At the median depth (400 feet), a complete well would cost roughly $12,500 to $30,500, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Stockdale?

When the wells were finished, the water stood a median 81 feet below the surface (29 wells), well above the bottom: the typical well holds about 319 feet of water. The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Stockdale?

Stockdale is inside the Evergreen Underground Water Conservation District. Groundwater conservation districts in Texas can require registering or permitting a new well, keeping set distances from property lines and other wells, and paying fees. Rules differ from district to district: ask the district before drilling.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/stockdale-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources