Skip to content
ENES
Marketplace

How deep are water wells in Rose City, Texas?

Only 18 home water wells in and around Rose City, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 155 to 478 feet deep (median 409 ft). All the wells the model covers are completed in the Chicot Aquifer, according to the state's northern Gulf Coast Aquifer model (TWDB). Estimated cost of a complete well at the median depth: $12,500 to $31,000.

This page is based on fewer than 30 wells, so it is kept out of search engines until more reports come in. Treat every figure as a rough guide.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointOrange County
What is under Rose City, TexasUnderground column at the center of Rose City: median well 409 ft, middle half 155 to 478 ft, water at 41 ft, and the layers of the state's model with their thickness.Chicot: 0 to 1,436 ftChicotcontinues to 8,074 ft0200400600ftGround level · 20 ft above sea levelMedian well: 409 ftWater standing in the well from 41 ftWater level41 ftMiddle half155–478 ftMedian well409 ft

Under Rose City, Orange County

Layers at the center of Rose City from TWDB's northern Gulf Coast Aquifer model (cells of about 0.62 mile (1 km)), at true depth scale. The well and the water are the median of 18 real wells.

Home wells in and around Rose City

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Rose City and about 2 miles around it

Key figures

Typical depth (middle half)
155 to 478 feet
Median depth
409 feet
Deepest 10% are past
500 feet
Water level (median)
41 feet
18 wells
Yield (median)
19 gpm
10 wells, gallons per minute
Wells used
18
Since 2001
Inside the city limits
0
the rest within 2 miles
All years on file
18
median 409 ft, since 2004
Confidence
Few wells (10 to 29)

When the wells were finished, the water stood a median 41 feet below the surface (18 wells), well above the bottom: the typical well holds about 368 feet of water.

What is under Rose City, TexasUnderground column at the center of Rose City: median well 409 ft, middle half 155 to 478 ft, water at 41 ft, and the layers of the state's model with their thickness.Chicot: 0 to 1,436 ftChicotcontinues to 8,074 ft0200400600ftGround level · 20 ft above sea levelMedian well: 409 ftWater standing in the well from 41 ftWater level41 ftMiddle half155–478 ftMedian well409 ft
Layers at the center of Rose City from TWDB's northern Gulf Coast Aquifer model (cells of about 0.62 mile (1 km)), at true depth scale. The well and the water are the median of 18 real wells.

Which formation do wells in Rose City draw from?

All the wells the model covers are completed in the Chicot Aquifer, according to the state's northern Gulf Coast Aquifer model (TWDB).

Layer (state's model)ShareWellsTypical depth (ft)
Chicot100%18155–478

Only 28% of these wells have the water-bearing interval on their report (reports before about 2012 rarely do). For the others we use the bottom of the hole, which tends to read one layer deeper than where the water actually comes from.

The layers under the center of Rose City

From the state's model, at 20 feet above sea level. These are the model's depths at that one point, not those of any particular lot.

Depths in feet below ground.
Layer (state's model)Top (ft)Bottom (ft)Thickness (ft)
Chicotsand, silt and clay01,4361,436
Evangelinesand and clay1,4363,3451,909
Jasper, Catahoula and Burkevillesand, sandstone, clay and volcanic tuff3,3458,0744,729

Depth over time

Too few wells per period in and around Rose City to compare depth over time. Since 2004, 18 home wells have been reported, with a median of 409 feet.

PeriodMedian depth (ft)Wells
2001–2005under 10 wells3
2006–2010under 10 wells8
2011–2015under 10 wells2
2016–2020under 10 wells4
2021–2025under 10 wells1

What a well costs in Rose City

At the median depth for Rose City (409 feet), a complete home well would cost roughly $12,500 to $31,000: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (155 to 478 feet) the range runs from $6,500 to $35,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Rose City, Texas?

Only 18 home water wells in and around Rose City, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 155 to 478 feet deep (median 409 ft). One in ten goes past 500 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

What aquifer or formation do wells in Rose City draw from?

All the wells the model covers are completed in the Chicot Aquifer, according to the state's northern Gulf Coast Aquifer model (TWDB). This is an estimate from the state's regional model, not a survey of the lot.

How much does a water well cost in Rose City?

At the median depth (409 feet), a complete well would cost roughly $12,500 to $31,000, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Rose City?

When the wells were finished, the water stood a median 41 feet below the surface (18 wells), well above the bottom: the typical well holds about 368 feet of water. The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Rose City?

In the state's boundary file (current as of November 2019) no groundwater conservation district covers Rose City. Districts created or enlarged since then are missing from that file, so confirm with the county or TWDB before drilling. Anywhere in Texas the well must be drilled by a licensed driller, who files the report with the state.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

Only 28% of these wells have the water-bearing interval on their report (reports before about 2012 rarely do). For the others we use the bottom of the hole, which tends to read one layer deeper than where the water actually comes from.

How well it works: In 14,333 wells in the area of the state's northern Gulf Coast Aquifer model (Houston and Southeast Texas) where the State of Texas recorded the aquifer, the formation our method says the well draws from (as grouped on these pages) is the one the state recorded in about 83% of them, and that formation or the one next to it in at least 99%; of the 3,578 of those wells that the state records in the Evangeline, it names the Evangeline for about 51% and the Chicot for most of the rest.

  • The layers come from the Texas Water Development Board's northern Gulf Coast Aquifer model, with cells of about 0.62 mile (1 km). It is a regional model, not a survey of any lot.
  • The state's model has cells of about 3,277 ft (1 km, 0.62 mile); we read it on a grid of about 0.6 by 0.7 miles. It is not a survey of any lot, so we give ranges.
  • Figures go by three groups: Chicot, Evangeline, and Jasper and Catahoula with the Burkeville. The state's records cannot tell the Burkeville, the Jasper and the Catahoula apart at a well (alone, the Burkeville matched 33% and the Catahoula 50%), so they are never named one by one as the formation of a well or a place.
  • The line between the Chicot and the Evangeline is drawn differently by different studies. The state's records put about half of their Evangeline wells in what the model draws as the Chicot, mostly deeper wells in Harris, Montgomery, Waller, Liberty and Austin counties. Where both appear, the split is approximate.
  • "Near or below the base" means the well ends near or below the base of the Gulf Coast Aquifer (under the Catahoula: Jackson Group, Yegua and older). It is 1.3% of home wells; half of them end within about 85 ft of the base. That is not an error: the model simply ends there.
  • The model's top layer is a uniform 49 ft slab for the water table zone, not a rock unit; we merge it into the unit beneath. The model also covers Colorado, Lavaca, Fayette, Wharton and Matagorda counties (outside Groundwater Management Area 14), with the same framework. Texas part only.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/rose-city-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources