How deep are water wells in Port O'Connor, Texas?
Only 28 home water wells in and around Port O'Connor, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 212 to 228 feet deep (median 220 ft). Estimated cost of a complete well at the median depth: $8,000 to $19,500.
This page is based on fewer than 30 wells, so it is kept out of search engines until more reports come in. Treat every figure as a rough guide.
Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.
Under Port O'Connor, Calhoun County
The well and the water are the median of 28 real wells. This atlas does not have a state layer model for this area yet.
Digging in…
Home wells in and around Port O'Connor
Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.
Well depth (ft)
- <100
- 100
- 200
- 300
- 400
- 600
- 800+
Dashed line: Port O'Connor and about 2 miles around it
Green: aquifer mapped by the state
Key figures
- Typical depth (middle half)
- 212 to 228 feet
- Median depth
- 220 feet
- Deepest 10% are past
- 243 feet
- Water level (median)
- 18 feet
- 28 wells
- Yield (median)
- 62.5 gpm
- 26 wells, gallons per minute
- Wells used
- 28
- Since 2001
- Inside the city limits
- 28
- the rest within 2 miles
- All years on file
- 28
- median 220 ft, since 2002
- Confidence
- Few wells (10 to 29)
When the wells were finished, the water stood a median 18 feet below the surface (28 wells), well above the bottom: the typical well holds about 202 feet of water.
Which formation do wells in Port O'Connor draw from?
We cannot say yet for Port O'Connor. This atlas assigns layers with the TWDB layered models processed so far (the Northern Trinity and Woodbine model, the Hill Country Trinity model, the northern Gulf Coast Aquifer model and the High Plains Aquifer System model), and none covers this area with enough wells. The depth, water level and yield on this page do come from the real wells here.
Depth over time
Too few wells per period in and around Port O'Connor to compare depth over time. Since 2002, 28 home wells have been reported, with a median of 220 feet.
| Period | Median depth (ft) | Wells |
|---|---|---|
| 2001–2005 | 212 | 11 |
| 2006–2010 | under 10 wells | 3 |
| 2016–2020 | under 10 wells | 9 |
| 2021–2025 | under 10 wells | 4 |
| 2026 | under 10 wells | 1 |
What a well costs in Port O'Connor
At the median depth for Port O'Connor (220 feet), a complete home well would cost roughly $8,000 to $19,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (212 to 228 feet) the range runs from $8,000 to $20,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.
Where it sits
- Wells in Calhoun County
- Calhoun County Groundwater Conservation District (groundwater district)
- Unincorporated community (Census-designated place) · 28.4463, -96.4205
Nearby places
Median depth of home wells in each place.
- Port Lavaca 238 ft
- Seadrift 190 ft
- Palacios 372 ft
- Lolita 118 ft
- Vanderbilt 163 ft
- Tivoli 140 ft
Common questions
How deep do you have to drill a well in Port O'Connor, Texas?
Only 28 home water wells in and around Port O'Connor, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 212 to 228 feet deep (median 220 ft). One in ten goes past 243 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.
How much does a water well cost in Port O'Connor?
At the median depth (220 feet), a complete well would cost roughly $8,000 to $19,500, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.
How deep is the water in Port O'Connor?
When the wells were finished, the water stood a median 18 feet below the surface (28 wells), well above the bottom: the typical well holds about 202 feet of water. The level moves with drought and from one well to the next.
Do I need a permit to drill a well in Port O'Connor?
Port O'Connor is inside the Calhoun County Groundwater Conservation District. Groundwater conservation districts in Texas can require registering or permitting a new well, keeping set distances from property lines and other wells, and paying fees. Rules differ from district to district: ask the district before drilling.
How these numbers are made
We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.
These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.
Read the full methodology · Download the data (CSV, CC BY 4.0)
How to cite
TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/port-oconnor-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.
Sources
- Submitted Driller's Reports database, Texas Water Development Board (TWDB) (file of November 10, 2026)
- Texas place boundaries, U.S. Census Bureau (2023 cartographic boundary file)
- Ground elevation: Terrain Tiles (Mapzen), Registry of Open Data on AWS
- TWDB well report viewer (each well's official report)