Skip to content
ENES
Marketplace

How deep are water wells in Junction, Texas?

Home water wells in and around Junction, Texas vary a lot in depth: the middle half are 135 to 380 feet deep (median 260 ft, 40 wells drilled in the last 10 years), so look at the wells closest to the tract. Estimated cost of a complete well at the median depth: $9,000 to $22,000.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointKimble County
What is under Junction, TexasUnderground column at the center of Junction: median well 260 ft, middle half 135 to 380 ft, water at 170 ft.No state layer model here yet0200400600ftGround levelMedian well: 260 ftWater standing in the well from 170 ftWater level170 ftMiddle half135–380 ftMedian well260 ft

Under Junction, Kimble County

The well and the water are the median of 40 real wells. This atlas does not have a state layer model for this area yet.

Home wells in and around Junction

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Junction and about 2 miles around it

Key figures

Typical depth (middle half)
135 to 380 feet
Median depth
260 feet
Deepest 10% are past
500 feet
Water level (median)
170 feet
38 wells
Yield (median)
8 gpm
35 wells, gallons per minute
Wells used
40
In the last 10 years
Inside the city limits
4
the rest within 2 miles
All years on file
75
median 230 ft, since 2001
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 170 feet below the surface (38 wells).

What is under Junction, TexasUnderground column at the center of Junction: median well 260 ft, middle half 135 to 380 ft, water at 170 ft.No state layer model here yet0200400600ftGround levelMedian well: 260 ftWater standing in the well from 170 ftWater level170 ftMiddle half135–380 ftMedian well260 ft
The well and the water are the median of 40 real wells. This atlas does not have a state layer model for this area yet.

Which formation do wells in Junction draw from?

We cannot say yet for Junction. This atlas assigns layers with the TWDB layered models processed so far (the Northern Trinity and Woodbine model, the Hill Country Trinity model, the northern Gulf Coast Aquifer model and the High Plains Aquifer System model), and none covers this area with enough wells. The depth, water level and yield on this page do come from the real wells here.

See the aquifers mapped under Kimble County

Depth over time

There are not enough wells in both 2003 to 2007 and 2021 to 2025 (at least 30 in each) to say with confidence whether wells in and around Junction are getting deeper. For reference, the median was 140 feet in 2001 to 2005 (13 wells) and 250 feet in 2021 to 2025 (24 wells).

PeriodMedian depth (ft)Wells
2001–200514013
2006–2010under 10 wells8
2011–201520013
2016–202026016
2021–202525024
2026under 10 wells1

What a well costs in Junction

At the median depth for Junction (260 feet), a complete home well would cost roughly $9,000 to $22,000: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (135 to 380 feet) the range runs from $6,000 to $29,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Junction, Texas?

Home water wells in and around Junction, Texas vary a lot in depth: the middle half are 135 to 380 feet deep (median 260 ft, 40 wells drilled in the last 10 years), so look at the wells closest to the tract. One in ten goes past 500 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

How much does a water well cost in Junction?

At the median depth (260 feet), a complete well would cost roughly $9,000 to $22,000, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Junction?

When the wells were finished, the water stood a median 170 feet below the surface (38 wells). The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Junction?

Junction is inside the Kimble County Groundwater Conservation District. Groundwater conservation districts in Texas can require registering or permitting a new well, keeping set distances from property lines and other wells, and paying fees. Rules differ from district to district: ask the district before drilling.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/junction-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources