Skip to content
ENES
Marketplace

How deep are water wells in Jacksonville, Texas?

Home water wells in and around Jacksonville, Texas are typically 235 to 620 feet deep (median 500 ft, 33 wells drilled in the last 10 years). Estimated cost of a complete well at the median depth: $15,000 to $36,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointCherokee County
What is under Jacksonville, TexasUnderground column at the center of Jacksonville: median well 500 ft, middle half 235 to 620 ft, water at 120 ft.No state layer model here yet0200400600800ftGround levelMedian well: 500 ftWater standing in the well from 120 ftWater level120 ftMiddle half235–620 ftMedian well500 ft

Under Jacksonville, Cherokee County

The well and the water are the median of 33 real wells. This atlas does not have a state layer model for this area yet.

Home wells in and around Jacksonville

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Jacksonville and about 2 miles around it

Key figures

Typical depth (middle half)
235 to 620 feet
Median depth
500 feet
Deepest 10% are past
680 feet
Water level (median)
120 feet
17 wells
Yield (median)
15 gpm
29 wells, gallons per minute
Wells used
33
In the last 10 years
Inside the city limits
2
the rest within 2 miles
All years on file
63
median 285 ft, since 2003
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 120 feet below the surface (17 wells), well above the bottom: the typical well holds about 380 feet of water.

What is under Jacksonville, TexasUnderground column at the center of Jacksonville: median well 500 ft, middle half 235 to 620 ft, water at 120 ft.No state layer model here yet0200400600800ftGround levelMedian well: 500 ftWater standing in the well from 120 ftWater level120 ftMiddle half235–620 ftMedian well500 ft
The well and the water are the median of 33 real wells. This atlas does not have a state layer model for this area yet.

Which formation do wells in Jacksonville draw from?

We cannot say yet for Jacksonville. This atlas assigns layers with the TWDB layered models processed so far (the Northern Trinity and Woodbine model, the Hill Country Trinity model, the northern Gulf Coast Aquifer model and the High Plains Aquifer System model), and none covers this area with enough wells. The depth, water level and yield on this page do come from the real wells here.

See the aquifers mapped under Cherokee County

Depth over time

There are not enough wells in both 2003 to 2007 and 2021 to 2025 (at least 30 in each) to say with confidence whether wells in and around Jacksonville are getting deeper. For reference, the median was 189 feet in 2006 to 2010 (10 wells) and 530 feet in 2021 to 2025 (17 wells).

PeriodMedian depth (ft)Wells
2001–2005under 10 wells4
2006–201018910
2011–201540015
2016–202050015
2021–202553017
2026under 10 wells2

What a well costs in Jacksonville

At the median depth for Jacksonville (500 feet), a complete home well would cost roughly $15,000 to $36,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (235 to 620 feet) the range runs from $8,500 to $43,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Jacksonville, Texas?

Home water wells in and around Jacksonville, Texas are typically 235 to 620 feet deep (median 500 ft, 33 wells drilled in the last 10 years). One in ten goes past 680 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

How much does a water well cost in Jacksonville?

At the median depth (500 feet), a complete well would cost roughly $15,000 to $36,500, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Jacksonville?

When the wells were finished, the water stood a median 120 feet below the surface (17 wells), well above the bottom: the typical well holds about 380 feet of water. The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Jacksonville?

Jacksonville is inside the Neches and Trinity Valleys Groundwater Conservation District. Groundwater conservation districts in Texas can require registering or permitting a new well, keeping set distances from property lines and other wells, and paying fees. Rules differ from district to district: ask the district before drilling.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/jacksonville-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources