Skip to content
ENES
Marketplace

How deep are water wells in Itasca, Texas?

Only 25 home water wells in and around Itasca, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 240 to 340 feet deep (median 280 ft). Nearly all draw from the Woodbine Aquifer (92%), according to the state's Northern Trinity and Woodbine model (TWDB). Estimated cost of a complete well at the median depth: $9,500 to $23,500.

This page is based on fewer than 30 wells, so it is kept out of search engines until more reports come in. Treat every figure as a rough guide.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointHill County
What is under Itasca, TexasUnderground column at the center of Itasca: median well 280 ft, middle half 240 to 340 ft, water at 180 ft, and the layers of the state's model with their thickness.Above the Woodbine: 0 to 144 ftAbove the WoodbineWoodbine: 144 to 313 ftWoodbineWashita and Fredericksburg: 313 to 878 ftWashita and Frederick…continues to 1,860 ft0100200300400500ftGround level · 702 ft above sea levelMedian well: 280 ftWater standing in the well from 180 ftWater level180 ftMiddle half240–340 ftMedian well280 ft

Under Itasca, Hill County

Layers at the center of Itasca from TWDB's Northern Trinity and Woodbine model (quarter mile cells, summarized here to about 1.3 miles), at true depth scale. The well and the water are the median of 25 real wells.

Home wells in and around Itasca

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Itasca and about 2 miles around it

Key figures

Typical depth (middle half)
240 to 340 feet
Median depth
280 feet
Deepest 10% are past
376 feet
Water level (median)
180 feet
23 wells
Yield (median)
15 gpm
25 wells, gallons per minute
Wells used
25
Since 2001
Inside the city limits
0
the rest within 2 miles
All years on file
25
median 280 ft, since 2007
Confidence
Few wells (10 to 29)

When the wells were finished, the water stood a median 180 feet below the surface (23 wells).

What is under Itasca, TexasUnderground column at the center of Itasca: median well 280 ft, middle half 240 to 340 ft, water at 180 ft, and the layers of the state's model with their thickness.Above the Woodbine: 0 to 144 ftAbove the WoodbineWoodbine: 144 to 313 ftWoodbineWashita and Fredericksburg: 313 to 878 ftWashita and Frederick…continues to 1,860 ft0100200300400500ftGround level · 702 ft above sea levelMedian well: 280 ftWater standing in the well from 180 ftWater level180 ftMiddle half240–340 ftMedian well280 ft
Layers at the center of Itasca from TWDB's Northern Trinity and Woodbine model (quarter mile cells, summarized here to about 1.3 miles), at true depth scale. The well and the water are the median of 25 real wells.

Which formation do wells in Itasca draw from?

Nearly all draw from the Woodbine Aquifer (92%), according to the state's Northern Trinity and Woodbine model (TWDB).

Only 80% bottom out inside the Woodbine Aquifer: the rest keep going deeper but take their water from that layer.

Layer (state's model)ShareWellsTypical depth (ft)
Woodbine92%23240–340
At or just below the base of the WoodbineWashita and Fredericksburg8%2—

For 88% of these wells the report says where the water enters and we use the middle of that interval; for the rest we use the bottom of the hole, which tends to read one layer too deep.

The layers under the center of Itasca

From the state's model, at 702 feet above sea level. These are the model's depths at that one point, not those of any particular lot.

Depths in feet below ground.
Layer (state's model)Top (ft)Bottom (ft)Thickness (ft)
Above the Woodbineshale, chalk and marl0144144
Woodbinesandstone with shale144313170
Washita and Fredericksburglimestone, marl and clay313878564
Upper Trinitysandstone, limestone and marl8781,490612
Lower Trinitysandstone with shale and limestone1,4901,860370

Depth over time

Too few wells per period in and around Itasca to compare depth over time. Since 2007, 25 home wells have been reported, with a median of 280 feet.

PeriodMedian depth (ft)Wells
2006–2010under 10 wells2
2011–2015under 10 wells1
2021–202529022

What a well costs in Itasca

At the median depth for Itasca (280 feet), a complete home well would cost roughly $9,500 to $23,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (240 to 340 feet) the range runs from $8,500 to $27,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Itasca, Texas?

Only 25 home water wells in and around Itasca, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 240 to 340 feet deep (median 280 ft). One in ten goes past 376 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

What aquifer or formation do wells in Itasca draw from?

Nearly all draw from the Woodbine Aquifer (92%), according to the state's Northern Trinity and Woodbine model (TWDB). This is an estimate from the state's regional model, not a survey of the lot.

How much does a water well cost in Itasca?

At the median depth (280 feet), a complete well would cost roughly $9,500 to $23,500, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Itasca?

When the wells were finished, the water stood a median 180 feet below the surface (23 wells). The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Itasca?

Itasca is inside the Prairielands Groundwater Conservation District. Groundwater conservation districts in Texas can require registering or permitting a new well, keeping set distances from property lines and other wells, and paying fees. Rules differ from district to district: ask the district before drilling.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 88% of these wells the report says where the water enters and we use the middle of that interval; for the rest we use the bottom of the hole, which tends to read one layer too deep.

How well it works: In 7,977 wells in the area of the state's Northern Trinity and Woodbine model (North and Central Texas) where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 74% of them, and that layer or the one next to it in at least 95%; among the 3,130 of those wells that the state places in a Trinity layer (Paluxy to Hosston) it is about 56%.

  • The layers come from the Texas Water Development Board's Northern Trinity and Woodbine model, with quarter mile cells, summarized here to about 1.3 miles. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
  • In this model every layer is at least 30 feet thick, even where the real rock is thinner or missing. Thin layers and the edges of the model are approximate.
  • Inside the Trinity this atlas does not name single model layers: it groups the Paluxy and Glen Rose (upper Trinity) and groups the Hensell, Pearsall and Hosston (lower Trinity, Twin Mountains and Travis Peak), because the check against the state's codes shows the method cannot separate them reliably.
  • "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/itasca-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources