Skip to content
ENES
Marketplace

How deep are water wells in Georgetown, Texas?

Home water wells in and around Georgetown, Texas are typically 340 to 830 feet deep (median 570 ft, 249 wells drilled in the last 10 years). No single layer dominates: 42% draw from the Washita and Fredericksburg groups, 34% from the upper Trinity (Paluxy and Glen Rose) and 24% from the lower Trinity (Twin Mountains and Travis Peak), according to the state's Northern Trinity and Woodbine model (TWDB). Estimated cost of a complete well at the median depth: $17,000 to $40,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointWilliamson County
What is under Georgetown, TexasUnderground column at the center of Georgetown: median well 570 ft, middle half 340 to 830 ft, water at 340 ft, and the layers of the state's model with their thickness.Washita and Fredericksburg: 0 to 397 ftWashita and Frederick…Upper Trinity: 397 to 1,250 ftUpper Trinitycontinues to 1,843 ft02004006008001,000ftGround level · 779 ft above sea levelMedian well: 570 ftWater standing in the well from 340 ftWater level340 ftMiddle half340–830 ftMedian well570 ft

Under Georgetown, Williamson County

Layers at the center of Georgetown from TWDB's Northern Trinity and Woodbine model (quarter mile cells, summarized here to about 1.3 miles), at true depth scale. The well and the water are the median of 249 real wells.

Home wells in and around Georgetown

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Georgetown and about 2 miles around it

Key figures

Typical depth (middle half)
340 to 830 feet
Median depth
570 feet
Deepest 10% are past
896 feet
Water level (median)
340 feet
202 wells
Yield (median)
50 gpm
172 wells, gallons per minute
Wells used
249
In the last 10 years
Inside the city limits
43
the rest within 2 miles
All years on file
601
median 570 ft, since 1998
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 340 feet below the surface (202 wells).

What is under Georgetown, TexasUnderground column at the center of Georgetown: median well 570 ft, middle half 340 to 830 ft, water at 340 ft, and the layers of the state's model with their thickness.Washita and Fredericksburg: 0 to 397 ftWashita and Frederick…Upper Trinity: 397 to 1,250 ftUpper Trinitycontinues to 1,843 ft02004006008001,000ftGround level · 779 ft above sea levelMedian well: 570 ftWater standing in the well from 340 ftWater level340 ftMiddle half340–830 ftMedian well570 ft
Layers at the center of Georgetown from TWDB's Northern Trinity and Woodbine model (quarter mile cells, summarized here to about 1.3 miles), at true depth scale. The well and the water are the median of 249 real wells.

Which formation do wells in Georgetown draw from?

No single layer dominates: 42% draw from the Washita and Fredericksburg groups, 34% from the upper Trinity (Paluxy and Glen Rose) and 24% from the lower Trinity (Twin Mountains and Travis Peak), according to the state's Northern Trinity and Woodbine model (TWDB).

Layer (state's model)ShareWellsTypical depth (ft)
Washita and Fredericksburg42%104200–422
Upper TrinityPaluxy and Glen Rose34%85810–900
Lower TrinityTwin Mountains and Travis Peak24%59545–795
Above the Woodbine<1%1—

For 87% of these wells the report says where the water enters and we use the middle of that interval; for the rest we use the bottom of the hole, which tends to read one layer too deep.

The layers under the center of Georgetown

From the state's model, at 779 feet above sea level. These are the model's depths at that one point, not those of any particular lot.

Depths in feet below ground.
Layer (state's model)Top (ft)Bottom (ft)Thickness (ft)
Washita and Fredericksburglimestone, marl and clay0397397
Upper Trinitysandstone, limestone and marl3971,250854
Lower Trinitysandstone with shale and limestone1,2501,843593

Depth over time

Home well depth in and around Georgetown has not changed meaningfully in 20 years: the median was 534 feet in 2003 to 2007 and 610 feet in 2021 to 2025 (a difference under 10% or within the margin of error).

PeriodMedian depth (ft)Wells
2001–200553890
2006–201054599
2011–2015690137
2016–2020535140
2021–2025610125
2026under 10 wells7

What a well costs in Georgetown

At the median depth for Georgetown (570 feet), a complete home well would cost roughly $17,000 to $40,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (340 to 830 feet) the range runs from $11,000 to $56,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Georgetown, Texas?

Home water wells in and around Georgetown, Texas are typically 340 to 830 feet deep (median 570 ft, 249 wells drilled in the last 10 years). One in ten goes past 896 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

What aquifer or formation do wells in Georgetown draw from?

No single layer dominates: 42% draw from the Washita and Fredericksburg groups, 34% from the upper Trinity (Paluxy and Glen Rose) and 24% from the lower Trinity (Twin Mountains and Travis Peak), according to the state's Northern Trinity and Woodbine model (TWDB). This is an estimate from the state's regional model, not a survey of the lot.

How much does a water well cost in Georgetown?

At the median depth (570 feet), a complete well would cost roughly $17,000 to $40,500, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Georgetown?

When the wells were finished, the water stood a median 340 feet below the surface (202 wells). The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Georgetown?

In the state's boundary file (current as of November 2019) no groundwater conservation district covers Georgetown. Districts created or enlarged since then are missing from that file, so confirm with the county or TWDB before drilling. Anywhere in Texas the well must be drilled by a licensed driller, who files the report with the state.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 87% of these wells the report says where the water enters and we use the middle of that interval; for the rest we use the bottom of the hole, which tends to read one layer too deep.

How well it works: In 7,977 wells in the area of the state's Northern Trinity and Woodbine model (North and Central Texas) where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 74% of them, and that layer or the one next to it in at least 95%; among the 3,130 of those wells that the state places in a Trinity layer (Paluxy to Hosston) it is about 56%.

  • The layers come from the Texas Water Development Board's Northern Trinity and Woodbine model, with quarter mile cells, summarized here to about 1.3 miles. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
  • In this model every layer is at least 30 feet thick, even where the real rock is thinner or missing. Thin layers and the edges of the model are approximate.
  • Inside the Trinity this atlas does not name single model layers: it groups the Paluxy and Glen Rose (upper Trinity) and groups the Hensell, Pearsall and Hosston (lower Trinity, Twin Mountains and Travis Peak), because the check against the state's codes shows the method cannot separate them reliably.
  • "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/georgetown-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources