Skip to content
ENES
Marketplace

How deep are water wells in Cleburne, Texas?

Home water wells in and around Cleburne, Texas are typically 480 to 598 feet deep (median 500 ft, 174 wells drilled in the last 10 years). Nearly all draw from the upper Trinity (Paluxy and Glen Rose, 95%), according to the state's Northern Trinity and Woodbine model (TWDB). Estimated cost of a complete well at the median depth: $15,000 to $36,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

See the wells and layers at an exact pointJohnson County
What is under Cleburne, TexasUnderground column at the center of Cleburne: median well 500 ft, middle half 480 to 598 ft, water at 390 ft, and the layers of the state's model with their thickness.Washita and Fredericksburg: 0 to 423 ftWashita and Frederick…Upper Trinity: 423 to 904 ftUpper Trinitycontinues to 1,220 ft0200400600800ftGround level · 822 ft above sea levelMedian well: 500 ftWater standing in the well from 390 ftWater level390 ftMiddle half480–598 ftMedian well500 ft

Under Cleburne, Johnson County

Layers at the center of Cleburne from TWDB's Northern Trinity and Woodbine model (quarter mile cells, summarized here to about 1.3 miles), at true depth scale. The well and the water are the median of 174 real wells.

Home wells in and around Cleburne

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Cleburne and about 2 miles around it

Key figures

Typical depth (middle half)
480 to 598 feet
Median depth
500 feet
Deepest 10% are past
657 feet
Water level (median)
390 feet
128 wells
Yield (median)
15 gpm
150 wells, gallons per minute
Wells used
174
In the last 10 years
Inside the city limits
14
the rest within 2 miles
All years on file
271
median 500 ft, since 2002
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 390 feet below the surface (128 wells), close to the bottom: the typical well holds only about 110 feet of water.

What is under Cleburne, TexasUnderground column at the center of Cleburne: median well 500 ft, middle half 480 to 598 ft, water at 390 ft, and the layers of the state's model with their thickness.Washita and Fredericksburg: 0 to 423 ftWashita and Frederick…Upper Trinity: 423 to 904 ftUpper Trinitycontinues to 1,220 ft0200400600800ftGround level · 822 ft above sea levelMedian well: 500 ftWater standing in the well from 390 ftWater level390 ftMiddle half480–598 ftMedian well500 ft
Layers at the center of Cleburne from TWDB's Northern Trinity and Woodbine model (quarter mile cells, summarized here to about 1.3 miles), at true depth scale. The well and the water are the median of 174 real wells.

Which formation do wells in Cleburne draw from?

Nearly all draw from the upper Trinity (Paluxy and Glen Rose, 95%), according to the state's Northern Trinity and Woodbine model (TWDB).

Layer (state's model)ShareWellsTypical depth (ft)
Upper TrinityPaluxy and Glen Rose95%165480–590
Washita and Fredericksburg4%7128–335
Lower TrinityTwin Mountains and Travis Peak1%2—

For 96% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

The layers under the center of Cleburne

From the state's model, at 822 feet above sea level. These are the model's depths at that one point, not those of any particular lot.

Depths in feet below ground.
Layer (state's model)Top (ft)Bottom (ft)Thickness (ft)
Washita and Fredericksburglimestone, marl and clay0423423
Upper Trinitysandstone, limestone and marl423904482
Lower Trinitysandstone with shale and limestone9041,220315

Depth over time

Home well depth in and around Cleburne has not changed meaningfully in 20 years: the median was 515 feet in 2003 to 2007 and 500 feet in 2021 to 2025 (a difference under 10% or within the margin of error).

PeriodMedian depth (ft)Wells
2001–200550220
2006–201052043
2011–201552530
2016–202050061
2021–2025500102
202652015

What a well costs in Cleburne

At the median depth for Cleburne (500 feet), a complete home well would cost roughly $15,000 to $36,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (480 to 598 feet) the range runs from $14,500 to $42,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Cleburne, Texas?

Home water wells in and around Cleburne, Texas are typically 480 to 598 feet deep (median 500 ft, 174 wells drilled in the last 10 years). One in ten goes past 657 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

What aquifer or formation do wells in Cleburne draw from?

Nearly all draw from the upper Trinity (Paluxy and Glen Rose, 95%), according to the state's Northern Trinity and Woodbine model (TWDB). This is an estimate from the state's regional model, not a survey of the lot.

How much does a water well cost in Cleburne?

At the median depth (500 feet), a complete well would cost roughly $15,000 to $36,500, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Cleburne?

When the wells were finished, the water stood a median 390 feet below the surface (128 wells), close to the bottom: the typical well holds only about 110 feet of water. The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Cleburne?

Cleburne is inside the Prairielands Groundwater Conservation District. Groundwater conservation districts in Texas can require registering or permitting a new well, keeping set distances from property lines and other wells, and paying fees. Rules differ from district to district: ask the district before drilling.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 96% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How well it works: In 7,977 wells in the area of the state's Northern Trinity and Woodbine model (North and Central Texas) where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 74% of them, and that layer or the one next to it in at least 95%; among the 3,130 of those wells that the state places in a Trinity layer (Paluxy to Hosston) it is about 56%.

  • The layers come from the Texas Water Development Board's Northern Trinity and Woodbine model, with quarter mile cells, summarized here to about 1.3 miles. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
  • In this model every layer is at least 30 feet thick, even where the real rock is thinner or missing. Thin layers and the edges of the model are approximate.
  • Inside the Trinity this atlas does not name single model layers: it groups the Paluxy and Glen Rose (upper Trinity) and groups the Hensell, Pearsall and Hosston (lower Trinity, Twin Mountains and Travis Peak), because the check against the state's codes shows the method cannot separate them reliably.
  • "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/cleburne-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources