Skip to content

How deep are water wells in Anson, Texas?

Only 14 home water wells in and around Anson, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 70 to 80 feet deep (median 75 ft). Estimated cost of a complete well at the median depth: $4,500 to $11,000.

This page is based on fewer than 30 wells, so it is kept out of search engines until more reports come in. Treat every figure as a rough guide.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

What is under Anson, TexasUnderground column at the center of Anson: median well 75 ft, middle half 70 to 80 ft, water at 30 ft.No state layer model here yet0255075100125ftGround levelMedian well: 75 ftWater standing in the well from 30 ftWater level30 ftMiddle half70–80 ftMedian well75 ft

Under Anson, Jones County

The well and the water are the median of 14 real wells. This atlas does not have a state layer model for this area yet.

Home wells in and around Anson

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dashed line: Anson and about 2 miles around it

Key figures

Typical depth (middle half)
70 to 80 feet
Median depth
75 feet
Deepest 10% are past
96 feet
Water level (median)
30 feet
12 wells
Yield (median)
15 gpm
13 wells, gallons per minute
Wells used
14
Since 2001
Inside the city limits
6
the rest within 2 miles
All years on file
14
median 75 ft, since 2002
Confidence
Few wells (10 to 29)

When the wells were finished, the water stood a median 30 feet below the surface (12 wells), well above the bottom: the typical well holds about 45 feet of water.

What is under Anson, TexasUnderground column at the center of Anson: median well 75 ft, middle half 70 to 80 ft, water at 30 ft.No state layer model here yet0255075100125ftGround levelMedian well: 75 ftWater standing in the well from 30 ftWater level30 ftMiddle half70–80 ftMedian well75 ft
The well and the water are the median of 14 real wells. This atlas does not have a state layer model for this area yet.

Which formation do wells in Anson draw from?

We cannot say yet for Anson. This atlas assigns layers with the TWDB layered models processed so far (the Northern Trinity and Woodbine model, the Hill Country Trinity model, the northern Gulf Coast Aquifer model and the High Plains Aquifer System model), and none covers this area with enough wells. The depth, water level and yield on this page do come from the real wells here.

See the aquifers mapped under Jones County

Depth over time

Too few wells per period in and around Anson to compare depth over time. Since 2002, 14 home wells have been reported, with a median of 75 feet.

PeriodMedian depth (ft)Wells
2001–2005under 10 wells7
2006–2010under 10 wells2
2021–2025under 10 wells5

What a well costs in Anson

At the median depth for Anson (75 feet), a complete home well would cost roughly $4,500 to $11,000: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (70 to 80 feet) the range runs from $4,500 to $11,500. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

Where it sits

Nearby places

Median depth of home wells in each place.

All Texas cities and towns

Common questions

How deep do you have to drill a well in Anson, Texas?

Only 14 home water wells in and around Anson, Texas have been reported since 2001, so treat this as a rough guide: the middle half are 70 to 80 feet deep (median 75 ft). One in ten goes past 96 feet. The depth a given tract needs depends on where it sits and what layers the driller hits.

How much does a water well cost in Anson?

At the median depth (75 feet), a complete well would cost roughly $4,500 to $11,000, by TerraFunded's estimate from published Texas driller prices. The real price comes from a licensed driller's quote.

How deep is the water in Anson?

When the wells were finished, the water stood a median 30 feet below the surface (12 wells), well above the bottom: the typical well holds about 45 feet of water. The level moves with drought and from one well to the next.

Do I need a permit to drill a well in Anson?

In the state's boundary file (current as of November 2019) no groundwater conservation district covers Anson. Districts created or enlarged since then are missing from that file, so confirm with the county or TWDB before drilling. Anywhere in Texas the well must be drilled by a licensed driller, who files the report with the state.

How these numbers are made

We count new and replacement domestic (home) wells whose coordinates fall inside the place boundary or within 2 miles of it. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/places/anson-tx. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources