Skip to content

Water wells in the lower Trinity (Twin Mountains and Travis Peak), Palo Pinto County, Texas

Home water wells that draw from the lower Trinity (Twin Mountains and Travis Peak) in Palo Pinto County, Texas are typically 100 to 140 feet deep (median 120 ft, 33 wells drilled in the last 10 years). It is the county's main layer: 55% of the 60 wells the state's model covers. They run about 80 feet shallower than the county's median well (200 ft). Estimated cost of a complete well at the median depth: $5,500 to $13,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

Which layer Palo Pinto County wells draw from

  • Lower Trinity (Twin Mountains and Travis Peak) 55% · 33 wells
  • Near or below the base of the Trinity 45% · 27 wells
County home wells covered by the Northern Trinity and Woodbine model (in the last 10 years).

Home wells in Palo Pinto County

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dark line: Palo Pinto County

Key figures

Typical depth (middle half)
100 to 140 feet
Median depth
120 feet
Deepest 10% are past
192 feet
Water level (median)
30 feet
11 wells
Yield (median)
10 gpm
27 wells, gallons per minute
Wells used
33
In the last 10 years
Share of the county's wells
55%
All years on file
51
median 100 ft, since 2004
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 30 feet below the surface (11 wells), well above the bottom: the typical well holds about 90 feet of water.

What this layer is

This group is the lower half of the Trinity in North and Central Texas, the Twin Mountains Formation in the north and the Travis Peak to the south: the Hensell sand, the Pearsall shale and limestone, and the Hosston sandstone and conglomerate at the bottom. The state's model draws three layers, each at least 30 feet thick. This atlas reports them together because the method cannot place a well in one of the three reliably. North and west of Fort Worth they are the lower part of the undivided Antlers Formation.

More about the lower Trinity (Twin Mountains and Travis Peak)

Depth over time

There are not enough wells in both 2003 to 2007 and 2021 to 2025 (at least 30 in each) to say with confidence whether wells in this layer in Palo Pinto County are getting deeper. For reference, the median was 100 feet in 2006 to 2010 (10 wells) and 120 feet in 2021 to 2025 (21 wells).

PeriodMedian depth (ft)Wells
2001–2005under 10 wells2
2006–201010010
2011–2015under 10 wells5
2016–202013012
2021–202512021
2026under 10 wells1

Common questions

How deep is a well in the lower Trinity (Twin Mountains and Travis Peak) in Palo Pinto County?

Home water wells that draw from the lower Trinity (Twin Mountains and Travis Peak) in Palo Pinto County, Texas are typically 100 to 140 feet deep (median 120 ft, 33 wells drilled in the last 10 years).

How many Palo Pinto County wells draw from this layer?

It is the county's main layer: 55% of the 60 wells the state's model covers. For 88% of these wells the report says where the water enters and we use the middle of that interval; for the rest we use the bottom of the hole, which tends to read one layer too deep.

How deep does the water stand?

When the wells were finished, the water stood a median 30 feet below the surface (11 wells), well above the bottom: the typical well holds about 90 feet of water.

What a well costs here

At the median depth for this layer in Palo Pinto County (120 feet), a complete home well would cost roughly $5,500 to $13,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (100 to 140 feet) the range runs from $5,000 to $15,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

How these numbers are made

We count new and replacement domestic (home) wells with a valid depth on their report. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 88% of these wells the report says where the water enters and we use the middle of that interval; for the rest we use the bottom of the hole, which tends to read one layer too deep.

How well it works: In 7,977 wells in the area of the state's Northern Trinity and Woodbine model (North and Central Texas) where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 74% of them, and that layer or the one next to it in at least 95%; among the 3,130 of those wells that the state places in a Trinity layer (Paluxy to Hosston) it is about 56%.

  • The layers come from the Texas Water Development Board's Northern Trinity and Woodbine model, with quarter mile cells, summarized here to about 1.3 miles. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
  • In this model every layer is at least 30 feet thick, even where the real rock is thinner or missing. Thin layers and the edges of the model are approximate.
  • Inside the Trinity this atlas does not name single model layers: it groups the Paluxy and Glen Rose (upper Trinity) and groups the Hensell, Pearsall and Hosston (lower Trinity, Twin Mountains and Travis Peak), because the check against the state's codes shows the method cannot separate them reliably.
  • "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/palo-pinto-county/twin-mountains. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources