Skip to content
ENES
Marketplace

Water wells in the upper Trinity (Paluxy and Glen Rose), Hood County, Texas

Home water wells that draw from the upper Trinity (Paluxy and Glen Rose) in Hood County, Texas are typically 200 to 340 feet deep (median 280 ft, 117 wells drilled in the last 10 years). It accounts for 12% of the 967 county wells the state's model covers; the main layer is the lower Trinity (Twin Mountains and Travis Peak) (82%). They run about 80 feet shallower than the county's median well (360 ft). In Hood County the state maps the Trinity as one undivided unit, the Antlers Formation, so the split between upper and lower Trinity is approximate. Estimated cost of a complete well at the median depth: $9,500 to $23,500.

Updated every day from Texas Water Development Board driller reports. Last update: November 11, 2026, using the state file of November 10, 2026.

All wells in Hood CountyUpper Trinity (Paluxy and Glen Rose) across Texas

Which layer Hood County wells draw from

Under Granbury, Hood County

County home wells covered by the Northern Trinity and Woodbine model (in the last 10 years).

Home wells in Hood County

Each dot is a home well from a state driller report, colored by depth. Tap one for its details and official report. Tap an empty spot to see what is under that point.

See underground

Well depth (ft)

  • <100
  • 100
  • 200
  • 300
  • 400
  • 600
  • 800+

Dark line: Hood County

Key figures

Typical depth (middle half)
200 to 340 feet
Median depth
280 feet
Deepest 10% are past
386 feet
Water level (median)
155 feet
83 wells
Yield (median)
20 gpm
106 wells, gallons per minute
Wells used
117
In the last 10 years
Share of the county's wells
12%
All years on file
191
median 240 ft, since 2003
Confidence
Standard (30 or more wells)

When the wells were finished, the water stood a median 155 feet below the surface (83 wells).

Which layer Hood County wells draw from

County home wells covered by the Northern Trinity and Woodbine model (in the last 10 years).

What this layer is

This group is the upper half of the Trinity in North and Central Texas: the Paluxy sand on top and the Glen Rose limestone and marl under it. The state's model draws them as two layers, but our check against the state's own aquifer codes shows the method cannot tell them apart reliably, so this atlas reports them together. North and west of Fort Worth the limestone gives way to sand and both become the upper part of the undivided Antlers Formation.

In Hood County the state maps the Trinity as one undivided unit, the Antlers Formation, so the split between upper and lower Trinity is approximate.

More about the upper Trinity (Paluxy and Glen Rose)

Depth over time

New home wells in this layer in Hood County are deeper than 20 years ago: the median went from 178 feet (2003 to 2007) to 280 feet (2021 to 2025), 58% more. Deeper wells do not always mean the water dropped: a driller may be going for another layer, better water or more reserve.

PeriodMedian depth (ft)Wells
2001–200518021
2006–201018029
2011–201514514
2016–202017533
2021–202528081
202628013

Places in Hood County with wells in this layer

Common questions

How deep is a well in the upper Trinity (Paluxy and Glen Rose) in Hood County?

Home water wells that draw from the upper Trinity (Paluxy and Glen Rose) in Hood County, Texas are typically 200 to 340 feet deep (median 280 ft, 117 wells drilled in the last 10 years).

How many Hood County wells draw from this layer?

It accounts for 12% of the 967 county wells the state's model covers; the main layer is the lower Trinity (Twin Mountains and Travis Peak) (82%). For 97% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How deep does the water stand?

When the wells were finished, the water stood a median 155 feet below the surface (83 wells).

What a well costs here

At the median depth for this layer in Hood County (280 feet), a complete home well would cost roughly $9,500 to $23,500: $25 to $60 per foot for drilling, casing and seal, plus $2,500 to $6,500 for the pump, pressure tank, controls and hookup at the well. Across the whole middle half of depths (200 to 340 feet) the range runs from $7,500 to $27,000. This is TerraFunded's estimate from published Texas prices, not a quote, and it leaves out trenching and the line to the house. Get prices from at least two licensed drillers.

How these numbers are made

We count new and replacement domestic (home) wells with a valid depth on their report. We use the last 10 years when there are at least 30 wells; otherwise all since 2001. The median is the middle well and the middle half runs from the 25th to the 75th percentile.

To tell which layer a well draws from, we take the ground elevation at its location, subtract the depth of the interval where water enters (or the bottom of the hole when the report does not give one) and see which layer of the state's model that point falls in.

For 97% of these wells the report says where the water enters (the screen or the open hole), and we use the middle of that interval.

How well it works: In 7,977 wells in the area of the state's Northern Trinity and Woodbine model (North and Central Texas) where the State of Texas recorded the aquifer, our estimate of the formation the well draws from names the same layer of the state's model in about 74% of them, and that layer or the one next to it in at least 95%; among the 3,130 of those wells that the state places in a Trinity layer (Paluxy to Hosston) it is about 56%.

  • The layers come from the Texas Water Development Board's Northern Trinity and Woodbine model, with quarter mile cells, summarized here to about 1.3 miles. It is a regional model, not a survey of any lot: between one model point and the next, the real depth of each layer can differ.
  • In this model every layer is at least 30 feet thick, even where the real rock is thinner or missing. Thin layers and the edges of the model are approximate.
  • Inside the Trinity this atlas does not name single model layers: it groups the Paluxy and Glen Rose (upper Trinity) and groups the Hensell, Pearsall and Hosston (lower Trinity, Twin Mountains and Travis Peak), because the check against the state's codes shows the method cannot separate them reliably.
  • In this area, north and west of Fort Worth, the state maps the Trinity as one undivided unit, the Antlers Formation. The model cuts it into layers by depth; the split between upper and lower Trinity shown here is approximate, and the depth ranges are the solid part.
  • "Near or below the base of the Trinity" means the well reaches the bottom of the model or passes it, often by tens of feet. Older rock that the model does not include may lie there.
  • We never use the model's water levels. The water level on this page is the one each driller measured when the well was finished.

These are depths of real wells drilled nearby, not a promise about any property. Groundwater can change over short distances and with drought. A licensed water well driller can tell you what to expect on a specific tract.

Read the full methodology · Download the data (CSV, CC BY 4.0)

How to cite

TerraFunded (2026). Texas Well Atlas: Underground. From Texas Water Development Board driller reports and groundwater availability models (data as of November 10, 2026). https://terrafunded.com/wells/hood-county/paluxy-glen-rose. License CC BY 4.0. https://doi.org/10.5281/zenodo.24126380.

Sources